The value is the examination
Recertification is often treated as a stamp, obtained to satisfy an audit. That sells it short. A certificate declares that a qualified examination found the iron fit for its next interval. Where the examination was thin, the paper misleads, and the iron is trusted on a false assurance.
Drilling and measurement equipment (DME) iron rarely fails on the day it is certified. It fails later, under loads the paper presumed it could carry. So we sell the examination, and the certificate follows it.
What a proper examination covers
We inspect each item against its actual load and service history, never its age alone. Wear, damage and defects are identified component by component. The item is pressure-tested to its required rating, and every reading is recorded. Chiksan-type iron, hammer unions, swivels and pressure-test equipment all run the same discipline.
On the asset’s clock
Recertification belongs on the equipment’s service cycle, set by what the iron has actually done since its last examination. We run the work in-country, so the iron is out of your hands for days, not the weeks an overseas turnaround takes.